Types Of Common Cooling Towers Of Water Chillers
There are three kinds of common cooling towers of water chillers: natural convection cooling tower, forced convection cooling tower, exhaust cooling tower, and another combination of three different operation modes. The larger the unit capacity is, the more perfect and completed the cooling tower structure is.
A natural convection cooling tower can be a fountain in front of a building or a spray at the top of a building. Both the fountain and the natural convection cooling tower depends on prevailing wind. When the prevailing wind volume is large, the circulating water temperature after cooling is also low. The fountain can be built on the ground or on the roof. However, no matter where it is located, the range of water spray must be within the pool area. Because the wind will blow water out of pool,causing aversion or financial damage. Forced convection and exhaust cooling water tower use fans to propel air through the cooling tower. As the the operating efficiency of this cooling tower can be fully guaranteed, it is one of the most widely used cooling towers. In some cooling towers, centrifugal fans are also be used to drive the air. When the air in the cooling tower needs to be piped out of the building, the centrifugal fan can overcome the static pressure in the pipe, so it is necessary to use a centrifugal fan. The cooling tower structure equipped with a centrifugal fan can be more compact, so it is very popular in some applications. These cooling towers are suitable for the units whose capacity and heat discharge are approximately below 500 tones.
If reprint please indicate the source--- Shanghai TianFeng Industrial Co.,Ltd www.tfsye.com